| --------------------------------------------------------- |
| Ordering Code |
Description |
| --------------------------------------------------------- |
| CL 30/40 |
Identification plastic strip suitable for
machine engraving or heat embossing.
1000 mm standard length. |
| --------------------------------------------------------- |
| Ordering Code |
Description |
| --------------------------------------------------------- |
CB 30/N
CB 40/N
|
Preassembled CB-30 or CB-40 with
'N' number of ways. |
| |
A
|
B |
C |
D |
CB 30/N
|
16.50
|
13.50 |
17.70 |
11.00 |
| CB 40/N |
18.50 |
15.95 |
20.60 |
11.85 |
TECHNICAL DATA:
Current carrying capacity
Body and End Plate
Test Voltage
Wire Size |
30/40 Amps
Thermoplastic material
2.0KV AC between adjacent terminals and
2.5KV AC between terminals and channels
CB 30 - 6 Sq. mm. (max.)
CB 40 - 10 Sq. mm. (max.) |
| MATERIALS : |
|
Connecting link
Screws
Channel
End Clamp and Screw |
Brass Nickel Plated
Steel Zinc Plated
Steel Zinc Plated
Steel Zinc Plated |
| |
|
MOUNTING INSTRUCTIONS:
- Fix the channel in required position using 2 BA or 3/16" BSF or M5 screws.
Slotted construction avoids the need for exact measurement.
- Spring the moulded block into the channel.
- Press downward until the other lip of the channel enters in the opposite end slot of the block.
The block will remain safely in position until the clamp is fitted.
- Close up the blocks until the moulded interlocks are engaged and fit a clamp at each end.
When cutting off the channel, it is advisable to leave it longer to accommodate possible future additions.
Should it be necessary to remove a block for any reason, loosen one end clamp, slide blocks apart until
the interlock is free, press the block towards springs and lift out.
All dimensions are in mm.
Due to continuous improvement in products, we reserve the right to alter specifications without prior notice
|
|
